Videojet 1280 Manual Pdf Install Access

Videojet 1280 Operator Manual covers essential procedures for installing, operating, and managing text on the printer. Key installation and text setup steps include: Installation Guidelines Personnel Requirements trained personnel

should perform installation to avoid damaging components or voiding the warranty. Mounting Options : The unit can be placed on a table or mounted using a mobile printer stand , static stand, or wall-mounting assembly. Initial Power-On videojet 1280 manual pdf install

: Ensure the status bar displays "PRINTER OFF" before starting the jet via the 8-inch touchscreen interface. Text and Message Setup Entering Text : Access the Job Editor to create or edit messages. You can enter Default Text User Prompts to instruct operators to enter data when a job is selected. Font Matrix : The 1280 supports single-line matrixes such as 5x5, 5x7, 7x9, 10x16, 16x24, and 25x34. Character Height : Text height is selectable from 0.079" (2mm) to 0.40" (10mm) depending on the chosen font. Custom Graphics Step 2: Search for the Correct Document Use

Step 2: Search for the Correct Document

Use the exact search terms:

• Videojet 1280 Operator Manual (PN: 3E9797 – for general use)
• Videojet 1280 Installation Guide (PN: 3E9800 – for install specifics)
• Videojet 1280 Site Preparation Guide (PN: S4-1280)

Performing the First Test Print

1. Load a piece of cardboard or white paper into the product sensor’s trigger area.
2. Press “Start Jet” on the screen. You should hear the characteristic high-pitched whine of the piezoelectric crystal.
3. Press “Test Print.”
4. Inspect the printed characters. The manual includes a “Print Quality Troubleshooting” chart:
   • Missing dots: Air in system – run "Purge" cycle.
   • Splatter: Print gap too large or charge voltage too high.
   • Blurry edges: Product vibration or incorrect dot delay.

3. Electrical Installation

• Input power: 100–240 VAC, 50/60 Hz, 120W typical.
• Grounding is mandatory – the PDF shows exactly which terminal to use.
• Do not share a circuit with large motors or VFDs.

Step 3: Connect Fluids (The Critical Part)

1. Open the fluid cabinet door.
2. Remove the red shipping plugs from the ink and make-up ports.
3. Install the dip tubes into the bottles.
4. Connect the fluid lines:
   • Blue cap → Ink bottle
   • Green cap → Make-up bottle
5. Press the bottle into the spring-loaded holders until you hear a click.

From the manual: “Never swap blue and green lines. Ink will gel inside the make-up line, requiring full fluid system replacement.” Videojet 1280 Operator Manual (PN: 3E9797 – for