Equipment Interview Questions Updated ((new)) | Static

Here’s a proper write-up for the document title “Static Equipment Interview Questions (Updated)” — suitable for a resume, LinkedIn post, internal knowledge base, or training repository.

Part 5: Advanced & Scenario-Based Questions (For Senior Roles)

These separate the junior engineer from the lead inspector. static equipment interview questions updated

Q12. Name four Non-Destructive Testing (NDT) methods you would specify for a new stainless steel reactor.

Answer (Updated):

1. PAUT (Phased Array) – For volumetric weld inspection (replacing RT due to no radiation risk).
2. Liquid Penetrant Testing (PT) – For surface crack detection (Stainless steel is non-magnetic, so MT won't work on austenitic SS).
3. Eddy Current Array (ECA) – For tube inspection.
4. Ferrite Testing – To ensure duplex/super duplex welds have the correct ferrite/austenite ratio (30-60%).

Q8. What is the significance of ASME Section VIII, Division 2, versus Division 1?

Answer:

• Div. 1: "Rules" for typical vessels. Conservative, simpler, lower cost.
• Div. 2: "Alternative Rules" (Stress analysis). Allows higher allowable stresses (2/3 yield vs 1/3.5 ultimate). Results in thinner, lighter vessels but requires rigorous FEA and proof testing. Used for high-pressure or cryogenic service.